{"id":13711,"date":"2014-08-18T14:22:20","date_gmt":"2014-08-18T14:22:20","guid":{"rendered":"https:\/\/aquatrolscompany.com\/what-happens-to-water-after-it-leaves-the-irrigation-system\/"},"modified":"2014-08-18T14:22:20","modified_gmt":"2014-08-18T14:22:20","slug":"what-happens-to-water-after-it-leaves-the-irrigation-system","status":"publish","type":"post","link":"https:\/\/aquatrolscompany.com\/en-ca\/what-happens-to-water-after-it-leaves-the-irrigation-system\/","title":{"rendered":"What Happens to Water After it Leaves the Irrigation System?"},"content":{"rendered":"\n
Much has been written about how to conserve water in turf and landscape situations. And well it should. Water is our most precious resource. We can\u2019t live without it, and we need to do all that we can to conserve it and preserve it, both in terms of quantity and quality.<\/p>\n\n\n\n
So far however, most of the attention has been directed towards the irrigation system. While this is a critical first step, many improvements have been made, and more can be made, to improve efficiencies in other areas and thus conserve more water.<\/p>\n\n\n\n
So what happens to that water once it leaves the control of the irrigation system? Mother Nature takes over. That\u2019s what happens. And Mother Nature has some cruel and inefficient ways of allowing water to interact with the soil.<\/p>\n\n\n\n
There are four primary ways that water interacts with the soil once it leaves the irrigation system.<\/p>\n\n\n\n
\n
It penetrates the soil and the plants use it.\u00a0 This is good.<\/li>\n\n\n\n
The water penetrates the surface but channels through the soil before it can be used by the plant.\u00a0 Not Good.<\/li>\n\n\n\n
The water doesn\u2019t penetrate and forms puddles on the surface.\u00a0 Not Good.<\/li>\n\n\n\n
The water doesn\u2019t penetrate and it runs off the surface.\u00a0 Not Good.<\/li>\n<\/ol>\n\n\n\n
These four situations can cause a well-designed and well-operated irrigation system with a high percentage distribution uniformity (DU) to lose that high efficiency.\u00a0 High surface DU\u2019s are compromised because the water can\u2019t get into the soil profile and\/or the water can’t uniformly move around within the soil profile.\u00a0 Total DU, which includes surface DU and subsurface DU, is much lower as a result.\u00a0 And this drop in total DU forces increased run times on the irrigation system to make up for the water lost to the inefficiencies of water interacting with the soil.<\/p>\n\n\n\n
So what do we do? Or What can<\/em> we do?<\/h2>\n\n\n\n
These inefficiencies are caused by four conditions:<\/p>\n\n\n\n
\n
Physical problems with the soil.<\/li>\n\n\n\n
Chemical problems with the soil.<\/li>\n\n\n\n
Water repellency problems with the soil.<\/li>\n\n\n\n
The natural behavior of water.<\/li>\n<\/ol>\n\n\n\n
There are many possible solutions or control methods to remedy the first two conditions listed. But in general, any physical problem is going to be mitigated by some kind of physical control method or cultural practice. Aerification, de-thatching, deep tining, venting, HydroJet, and PlanetAire are just some of the possible solutions. As for the chemical problems, these are mitigated by some kind of chemical means. Soil sulfur, sulfuric acid, gypsum and limestone are just some of the possible correction methods. The last two, soil water repellency and the natural behavior of water, are much easier to deal with since there is only one proven control method: the use of soil surfactants (otherwise known as wetting agents).<\/p>\n\n\n\n<\/figure>\n\n\n\n
Soil surfactants reduce instances of soil water repellency and lower the adhesive and cohesive tensions of water, reducing the natural behavior of water to cling to the surface (adhesion) or to other water molecules (cohesion). Without soil surfactants, these two tensions cause water to behave in a very erratic fashion as it interacts with the soil and organic matter.<\/p>\n\n\n\n
So when water leaves the irrigation system and it lands on the soil or organic layer, we need to be sure that it can get into the soil profile and move around within the soil profile in a very efficient manner. Simply letting it fall on the soil and allowing Mother Nature to take control can potentially destroy the high level of efficiency designed into the irrigation system. This is not “Water Smart.”<\/p>\n\n\n\n
Therefore, the next step in water conservation is to find these efficiency-robbing conditions and correct them so water can carry out its two given responsibilities, survival and distribution, to the highest degree possible.<\/p>\n\n\n\n
![\"\"](\"data:image\/svg+xml;base64,PHN2ZyB3aWR0aD0iMSIgaGVpZ2h0PSIxIiB4bWxucz0iaHR0cDovL3d3dy53My5vcmcvMjAwMC9zdmciPjwvc3ZnPg==\")
<\/figure>\n\n\n\n![\"\"](\"https:\/\/aquatrolscompany.com\/wp-content\/uploads\/2014\/08\/Cohesion-and-Adhesion.jpg\")
<\/figure>\n\n\n\n![\"\"](\"https:\/\/aquatrolscompany.com\/wp-content\/uploads\/2014\/08\/Ken-Mauser.jpg\")
<\/figure>\n\n\n\n